Peerless-AV SP850-V2X2 - Installation - Manual (Page 9)

9 of 10 ISSUED: 01-17-12 SHEET #: 125-9277-1
5° tilt
10° tilt
M6 SCREW
MOUNTING
PLATE
Slide one mesh sleeve ( F) over each cable. Use
cable ties ( G) to tighten both ends of mesh sleeves
to cables.
Note: Loop cable ties through cable mounts and
tighten cable and mesh sleeve to cable mounts.
6
F
CABLE MOUNTS
Optional: To lock mount in closed position, insert
one M5 x 40 mm screw ( DD) into tapped hole in
either top or bottom of flat plate.
Note: Screen not shown for clarity.
7
FLAT
PLATE
TAPPED HOLE
DD
TAPPED HOLE
Screen can tilt 5° or 10° forward.
Note: Screen must be securely attached to mounting plate with all fasteners before adjusting tilt.
To tilt screen 5° forward, lift and pull mounting plate forward until middle notch rests on M6 screw as shown in figure
8.1. Tighten M6 screw (both sides) and M10 screws (both sides).
To tilt screen 10° forward, lift and pull mounting plate forward until rear notch rests on M6 screw as shown in figure
8.2. Tighten M6 screw (both sides) and M10 screws (both sides).
Note: For security models, tighten M6 screw using security allen wrench (J). For all M10 screws, use 6 mm allen
wrench (not included).
8
M10 SCREW
G
0° tilt
DETAIL 3