Warning, Ainstallation to wood stud wall, Fig 2.1 2 – Peerless-AV SP850-V2X2 - Installation User Manual

Page 4: Fig 2.3 d, Fig 2.2 d a

4 of 10

ISSUED: 01-17-12 SHEET #: 125-9277-1

Installation to Wood Stud Wall

CL = stud centerline

Using a stud finder, locate the edges of the wood studs used in mounting this product. Use of an edge-to-edge stud

finder is highly recommended. Based on its edges and using a level, draw a vertical line down the center of each

stud. Mark a point (

point 1) on the right stud centerline where upper right slot will be located. Using a level, mark a

point (

point 2) on the left stud centerline level with point 1 as shown in figure 2.1. Drill 5/32" diameter holes 2-1/2"

deep through studs at the two points. Loosely fasten wall mount assembly (

A) to wall using two #14 x 2-1/2" wood

screws (

D) as shown in figure 2.2. Level, hold, and then tighten screws.

Mark two more points for bottom slots on the right and left stud centerlines. Drill 5/32" diameter holes 2-1/2" deep

through studs at the two points. Using two #14 x 2-1/2" wood screws, fasten bottom of wall mount assembly to wall

as shown in figure 2.3.
Skip to step 3 on page 6.

fig 2.1

POINT 1

POINT 2

fig 2.3

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all

attached hardware and components.

• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder

is highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations.

WARNING

fig 2.2