Peerless-AV SP850-V2X2 - Installation User Manual

Page 8

8 of 10

ISSUED: 01-17-12 SHEET #: 125-9277-1

FOR VESA 200 MOUNTING PATTERN:

Thread two M4 x 12 mm screws (

BB), leaving .25" exposed thread, into top holes on back of screen. Hook screen onto

mounting plate, and attach using two bottom M4 x 12 mm screws as shown in figures 4.4 and 4.5. Tighten all four screws.
FOR SCREENS WITH VESA MOUNTING PATTERN IN A POCKET:

Thread two retaining spacers (

I) onto two M4 x 20 mm screws (CC), leaving .25" exposed thread as shown in figure 4.6.

Thread M4 x 20 mm screws with retaining spacers into top holes on back of screen. Hook screen onto mounting plate,

and attach using bottom two M4 x 20 mm screws and retaining spacers as shown in figures 4.4 and 4.5. Tighten all four

screws.

MOUNTING PLATE

(

NOTE: MOUNTING PLATE

SHOWN WITHOUT FULL

WALL MOUNT ASSEMBLY

FOR CLARITY)

fig. 4.4

fig. 4.5

MOUNTING PLATE

(

NOTE: MOUNTING PLATE

SHOWN WITHOUT FULL

WALL MOUNT ASSEMBLY

FOR CLARITY)

Note: Flat panel screen

may appear slightly dif-

ferent than illustrated.

For screens with a hole

pattern in a pocket,

spacers (

L) go between

mounting plate and

screen.

fig. 4.6

GENERIC

ADAPTER

BRACKET

FOR INSTALLING TO PEERLESS PLP MODEL ADAPTER BRACKET (not UL listed)

Note: Refer to PLP model adapter bracket instruction sheet for attachment of adapter bracket to screen.

Thread two M10 x 15 mm screws (

H), leaving .25" exposed thread, into top holes on back of screen. Hook screen

onto mounting plate, and attach using two bottom M10 x 15 mm screws as shown in figures 5.1 and 5.2. Tighten

screws using 6 mm allen wrench (not included).

For screen compatibility please refer to the plasma interface list on our website

www.peerlessmounts.com or

call customer care for a screen specific adapter bracket (PLP models).

GENERIC ADAPTER

BRACKET

MOUNTING PLATE

fig. 5.1

fig. 5.2

MOUNTING PLATE

(

NOTE: MOUNTING PLATE

SHOWN WITHOUT FULL

WALL MOUNT ASSEMBLY

FOR CLARITY)