Peerless-AV ACC840 - Installation - Manual

ISSUED:12-14-01 SHEET#: 055-9068-3 11-10-04
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
1 of 4
IMPORTANT! Read entire instruction sheet
before you start installation and assembly.
Installation and Assembly - Vibration Absorber Ceiling Mount for Structural
Ceiling
Model:
ACC 840
Description
A anti- vibration mount
B rubber bumper
C plastic finishing caps
D #14 x 2.5 wood screw
E .26 x .7x .062 plastic washer
F rubber grommet
G M5 x .8 x 10 mm socket-pin screw
H M5 x .8 x 10 mm phillips screw
Parts List
Qty.
1
4
2
2
2
1
1
1
Part Number
055-0004
590-1124
590-1123
5S1-015-C03
540-9439
530-9401
520-1063
520-9250
Note: Actual parts may appear slightly different than illustrated.
Before you start check the parts list below to
make sure all of the parts shown are included.
D
E
F
A
B
C
G H
• Installer must verify that the ceiling will safely support
four times the combined weight of all attached equip-
ment and hardware.
WARNING
• If mounting to Unistrut ® , purchase model ACC 845. Model ACC 840 should be mounted to wood only. If the anti-
vibration mount is altered in any way it may not be as effective, or effective at all, in controlling vibration. In
addition, be certain that no part of the system, including any extension column that might be used, comes in
contact with the vibrating surface. If mounting through a drop ceiling, be sure to cut a large enough hole in the
ceiling tile as to avoid contact with the extension column. If using an escutcheon ring, be sure it does not come
in contact with the false ceiling. Also be sure to use the rubber bumper (B) provided.
WARNING