Peerless-AV DCS400 - Installation - Manual

ISSUED: 07-15-94 SHEET #: 142-9001-4 04-20-05
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
1 of 1
Structural Ceiling Decoupler Adapter
PATENT PENDING
ASSEMBLY INSTRUCTIONS
Before beginning assembly...
Please read entire instruction sheet and check the parts list to ensure that all components have been included.
Recommended tools...
Drill and 5/16" masonry drill bit, 7/16" torque wrench, hammer
MODELS
DCS 200
DCS 400
ceiling
INSTALLATION and componentry.
1. Use the ceiling plate as a guide to mark and drill
twelve 5/16" dia. holes to a depth of no less than 1 3/8".
2. After holes are drilled, align the ceiling plate with
the holes and hammer in the twelve Lok/Bolts
TM .
ALL FASTENERS MUST BE USED.
3. Be sure that the ceiling plate is snug to the ceiling.
4. Tighten each Lok/Bolt to 8 ft. lbs. (11 NM) torque.
5. DCS 200 ONLY
The #10-32 x 1/2" phillips screw has been provided to lock
the Peerless extension column into place after insertion (see
instructions provided with column).
For proper attachment of threaded extension pipe to DCS 200
see instruction sheet provided with extension pipe.
For proper attachment of Adjustable Multi-Display Extension Unit
to DCS 400 see instruction sheet provided with extension unit.
DCS 200
Lok/bolt Lok/bolt
DCS 400
Threaded
Fitting #10 x 1/2"
phillips screw
5
Extension
Column (sold
separately)
* COMBINED LOAD CAPACITY: 300 lbs.
*Total weight of components and hardware
2 3 4
7/16" Torque
Wrench
Structural
Ceiling
Plate
LOK/BOLT INSTALLATION - SIDE VIEW
PARTS LIST FOR DCS 400
PART NO.
QTY. DESCRIPTION
128-0421 1 STRUCTURAL CEILING DECOUPLER ADAPTER
560-9707 12 RAWL TM 5005 LOK/BOLT
PARTS LIST FOR DCS 200
PART NO.
QTY. DESCRIPTION
128-0419 1 STRUCTURAL CEILING DECOUPLER ADAPTER
560-9707 12 RAWL TM 5005 LOK/BOLT
520-9560 1 #10-32 x 1/2" PHILLIPS SCREW
© 2005 Peerless Industries, Inc. All rights reserved.
Peerless is a trademark of Peerless Industries, Inc.
R
This product is intended for use with UL Listed
products and must be installed by a qualified
professional installer.
• Installer must verify that the wall will safely support
four times the combined weight of all attached equip-
ment and hardware.
WARNING
• If you are using an extension pipe without a notch, drill
a 11/64 (0.172") dia. hole through the pipe and insert
the screw through the threaded fitting and pipe. Failure
to do so could cause the assembly to fail.
WARNING
* COMBINED LOAD CAPACITY: 1200 lbs.