Peerless-AV ACC560 - Installation - Manual (Page 2)

2 of 4 ISSUED: 02-06-07 SHEET #: 054-9125-2 07-30-07
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.
Drill two 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach ceiling plate (A) with two #14 x 2.5" (6
mm x 65 mm) wood screws (B) as shown using 3/8" (10 mm) socket wrench.
IMPORTANT: Be sure to drill holes into the joist CENTER!
Installation To Wood Joist Finished Ceilings,
Exposed Wood Joists, or Wood Beam Ceilings
• Installer must verify that the supporting surface will safely support the combined weight of mount and projector.
• Tighten wood screws so that ceiling plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is
highly recommended.
WARNING
B
B
A
WOOD JOIST
CEILING
1