Peerless-AV ACC908 - Installation - Manual (Page 3)

3 of 5 ISSUED: 04-28-03 SHEET #: 095-9161-3 08-16-04
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
C
A
Attach metal stud wall plate (A) to center of metal
stud using two 1/4-20 x 2.5" phillips screws (C) and
two 1/4-20 togglers (D) as shown below and in
Illustration A, but do not tighten until after the metal
stud wall plate (A) is securely fastened in step 3.
Pull screw (C) back until toggler (D) is flush with
metal stud and hold. Thread screw through with
fingers and loosely tighten.
Place screw (C) through metal stud wall plate (A).
Partially fasten toggler (D) to back of screw. Pivot
toggler ends 90° and push through hole in drywall.
D
C
C
D
DRYWALL
DRYWALL
METAL STUD
ILLUSTRATION A
A
A
Fasten metal stud wall plate (A) using four #8 x 1"
phillips sheet metal screws (G) as shown. Securely
tighten two 1/4-20 x 2.5" phillips screws (C).
G
D
C
• Product must be mounted through drywall that has a
minimum thickness of 1/2" and into metal studs, 26
gauge or heavier.
WARNING