Peerless-AV ACC952 - Installation - Manual (Page 4)

4 of 20 ISSUED: 04-05-11 SHEET #: 120-9105-1
Installation to Wood Stud Wall
1
• Tighten wood screws so that wall bracket is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations.
WARNING
C
A
E
WOOD STUD
DISPLAY
Apply foam pad (E) to bottom of wall bracket (A).
Use a stud fi nder to locate the edges of the stud. Use of an edge-to-edge stud fi nder is highly recommended.
Based on their edges, draw a vertical line down each stud’s center. Place wall bracket (A) on wall as a template,
resting on top of display. Secure wall bracket (A) to wall with security wood screw (C).