B&B Electronics 316TX-N - Manual - Manual (Page 11)

(Revised 2010-7-30) 11
Front Panel
From Top to Bottom and Left to Right:
Green LED lights when Power is connected
RJ45 Ports Auto sensing 10/100 BaseTX Connections
LNK
Link LED for Fiber Optic Port (only FX/FXE models)
ACT Activity LED for Fiber Optic Port (only FX/FXE models)
RX 100MB/s Fiber Optic RX Port (only FX/FXE models)
TX 100MB/s Fiber Optic TX Port (only FX/FXE models)
NOTE: Each RJ45 data port has two LED‟s located at the top or bottom of each connector. The bottom LED
indicates LINK status (green for 100Mb link, Orange for 10Mb link), and the top LED indicates ACTIVITY
(Green for Full Duplex activity, Orange for Half Duplex Activity).
LED’s: The table below describes the operating modes:
LED Color Description
GREEN Power is Applied
OFF Power is OFF
LNK
GREEN 100Mb Link between ports
ORANGE 10 Mb Link between ports
OFF No Link between ports
ACT
GREEN Data is active between ports
and operating in full duplex
ORANGE Data is active between ports
and operating in half duplex
OFF Data is inactive between
ports