beautypg.com

B&B Electronics 854-11121 - Manual User Manual

Page 6

background image

2


• OAM AH Functions

o

Discovery

o

Link Performance Monitoring

o

Remote Loopback

o

Fault Detection

o

Link Fault

o

Dying Gasp

o

Critical Event

• OAM CFM (SERVICE-OAM)

o

IEEE 802.1ag Connectivity Fault Management (OAM CFM)

o

OAM CFM Functions

o

Continuity Check

o

Loopback

• Speed/duplex modes

• 802.1q VLAN

• Extra tagging with user-defined VLAN tag Ethertype
• Ethertype 88A8 as defined in 802.1ad

• Command Line Interface capable (CLI)

• Telnet
• Password assignment via CLI, Telnet or iView²

• DIP Switch configuration for Modes
• Bandwidth Limiting

The IE-MultiWay can be installed as a standalone CPE device, back to back, or as a
Remote when connected to an iMcV-Giga-FiberLinX-II configured as a Host.

As a CPE device, the IE-MultiWay can behave as a remote to an iMcV-Giga-
FiberLinX-II host when:

1) The iMcV-Giga-FiberLinX-II:

• Is connected via the SFP ports on the IE-MultiWay

• Is configured as a Host

• Uses firmware version A1 860-00D1 or higher

2) The SNMP card (if present):

• Uses SNMP firmware version 953-00C8 or higher

3) The IE-MultiWay:

• Uses firmware version 123-00A1 or higher

When using iView

2

, the IE-MultiWay can be fully managed without an IP address

using a secure management channel. However, an IP address can be assigned