Absolute maximum ratings, Operating modes – Rainbow Electronics AT27C010(L) User Manual
Page 3
AT27C010(L)
3
Note:
1.
Minimum voltage is -0.6V dc which may undershoot to -2.0V for pulses of less than 20 ns. Maximum output pin voltage is
V
CC
+ 0.75V dc which may overshoot to +7.0 volts for pulses of less than 20 ns.
Notes:
1. X can be V
IL
or V
IH
.
2. Refer to Programming Characteristics.
3. V
H
= 12.0
±
0.5V.
4. Two identifier bytes may be selected. All Ai inputs are held low (V
IL
), except A9 which is set to V
H
and A0 which is toggled low
(V
IL
) to select the Manufacturer’s Identification byte and high (V
IH
) to select the Device Code byte.
Absolute Maximum Ratings*
Temperature Under Bias ................................ -55°C to +125°C
*NOTICE:
Stresses beyond those listed under “Absolute Maxi-
mum Ratings” may cause permanent damage to
the device. This is a stress rating only and func-
tional operation of the device at these or any other
conditions beyond those indicated in the opera-
tional sections of this specification is not implied.
Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
Storage Temperature ..................................... -65°C to +150°C
Voltage on Any Pin with
Respect to Ground .........................................-2.0V to +7.0V
(1)
Voltage on A9 with
Respect to Ground ......................................-2.0V to +14.0V
(1)
V
PP
Supply Voltage with
Respect to Ground .......................................-2.0V to +14.0V
(1)
Operating Modes
Mode\Pin
CE
OE
PGM
Ai
V
PP
Outputs
Read
V
IL
V
IL
X
(1)
Ai
X
D
OUT
Output Disable
X
V
IH
X
X
X
High Z
Standby
V
IH
X
X
X
X
High Z
Rapid Program
(2)
V
IL
V
IH
V
IL
Ai
V
PP
D
IN
PGM Verify
V
IL
V
IL
V
IH
Ai
V
PP
D
OUT
PGM Inhibit
V
IH
X
X
X
V
PP
High Z
Product Identification
(4)
V
IL
V
IL
X
A9 = V
H
(3)
A0 = V
IH
or V
IL
A1 - A16 = V
IL
X
Identification Code