Memory programming, Program (and data) memory lock bits, Fuse bits in attiny11 – Rainbow Electronics ATtiny12 User Manual
Page 44: Fuse bits in attiny12, Attiny11/12
44
ATtiny11/12
1006C–09/01
Memory
Programming
Program (and Data)
Memory Lock Bits
The ATtiny11/12 MCU provides two lock bits which can be left unprogrammed (“1”) or
can be programmed (“0”) to obtain the additional features listed in Table 21
. The lock
bits can only be erased with the Chip Erase command
.
Note:
1. In the High-voltage Serial Programming mode, further programming of the fuse bits
are also disabled. Program the fuse bits before programming the lock bits.
Fuse Bits in ATtiny11
The ATtiny11 has five fuse bits, FSTRT, RSTDISBL and CKSEL2..0.
•
FSTRT: See Table 7, “Start-up Times for the ATtiny11 (V
which value to use. Default value is unprogrammed (“1”).
•
When RSTDISBL is programmed (“0”), the external reset function of pin PB5 is
disabled.
Default value is unprogrammed (“1”).
•
CKSEL2..0: See Table 3, “Device Clocking Options Select,” on page 5, for which
combination of CKSEL2..0 to use. Default value is “100”, internal RC oscillator.
The status of the fuse bits is not affected by Chip Erase.
Note:
1. If the RSTDISBL Fuse is programmed, then the programming hardware should apply
+12V to PB5 while the ATtiny11 is in Power-on Reset. If not, the part can fail to enter
programming mode caused by drive contention on PB0.
Fuse Bits in ATtiny12
The ATtiny12 has eight fuse bits, BODLEVEL, BODEN, SPIEN, RSTDISBL and
CKSEL3..0. All the fuse bits are programmable in both High-voltage and Low-voltage
Serial programming modes. Changing the fuses does not have any effect while in pro-
gramming mode.
•
The BODLEVEL Fuse selects the Brown-out Detection level and changes the start-
up times. See “Brown-out Detection (ATtiny12)” on page 22. See Table 9, “ATtiny12
Clock Options and Start-up Times,” on page 20. Default value is programmed (“0”).
•
When the BODEN Fuse is programmed (“0”), the Brown-out Detector is enabled.
See “Brown-out Detection (ATtiny12)” on page 22. Default value is unprogrammed
(“1”).
•
When the SPIEN Fuse bit is programmed (“0”), Low-Voltage Serial Program and
Data Downloading is enabled. Default value is programmed (“0”). Unprogramming
this fuse while in the Low-Voltage Serial Programming mode will disable future in-
system downloading attempts.
•
When the RSTDISBL Fuse is programmed (“0”), the external reset function of pin
PB5 is disabled.
Default value is unprogrammed (“1”). Programming this fuse
while in the Low-Voltage Serial Programming mode will disable future in-system
downloading attempts.
Table 21. Lock Bit Protection Modes
Memory Lock Bits
Protection Type
Mode
LB1
LB2
1
1
1
No memory lock features enabled.
2
0
1
Further programming of the Flash (and EEPROM for ATtiny12) is
disabled.
3
0
0
Same as mode 2, and verify is also disabled.