Cobalt Digital COMPASS 9363 Multi-Format Reference Generator - Manual (Page 27)

9363-OM (V1.2) 9363 PRODUCT MANUAL 3-3
Operating Instructions
9363 Function Submenu List and Descriptions
Table 3-1 9363 Function Submenu List
Setup Controls
Provides controls for selecting input reference source
and configuring the four reference output pairs.
• Input Reference Source Select Selects source to be used as basic timing reference input as follows:
• Frame 1: Selects Frame 1 distributed reference signal as base
source.
• Frame 2: Selects Frame 2 distributed reference signal as base
source.
• Local: Selects Rear I/O Module External input BNC input as base
source.
Note: Card jumper JP2 must be set to REF IN position for this
input to work (this is the default factory position). See Setting
Card Jumpers (p. 2-1) in Chapter 2, “Installation” for more
information.
• Internal: Selects the card internal reference as base source.
• Reference Format Display Display reference format and rate of external (frame or external) reference
source. Provides selection of format when Internal source is selected.
• When an external reference source (Frame 1, Frame 2, or
External (Local)) is selected, displays received format and
rate.
• When the Internal reference source is being used (or when an
AES or Word Clock external input is received), Reference
Rate drop-down allows selection of internal base references
from choices listed below.
Setting Format/Rate Setting Format/Rate
60Hz 1080i 60 29.97Hz 1080p 29.97
59.94Hz 480i 5994 25Hz 1080p 25
50Hz 576i 50 24Hz 1080p 24
30Hz 1080p 30 23.98Hz 1080p 23.98