Turbosmart BOV ADAPTERS - Toyota Soarer - Manual (Page 3)

SOARER TT BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia Ph: +61(2) 9798 2866 Fax: +61 (2) 9798 2826 Email: [email protected]
USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA Ph: (760) 727 7610 Fax: (760) 727 7963 Email: [email protected]
PART NUMBER
FG-ADM-SOARER
Step 9. Remove the factory BOV.
Step 10. Take the O ring from the factory BOV and fit
it over the Soarer BOV blank supplied. Install the blank
over the pipe flange and secure it with the original
factory nut.
Step 11. Block off the factory return hose with the
29mm blanking plug supplied. Use the supplied 40mm
hose clamp to secure the plug. Then tighten, using a
7mm socket.
Step 12. Replace the factory return pipe on its
original fitting and secure it with a 40mm hose clamp
supplied. Tighten the clamp with a 7mm socket.
Step 13. Connect the pre-assembled silicon hose
assembly as shown in the diagram below:
Step 14. Install one end of the Silicon hose assembly
supplied onto the metal tube and secure with the 6mm
spring clamp supplied.
BOV
Blank
Pipe flange
Connect end to
throttle body Connect other end
to Turbosmart BOV
1700mm