beautypg.com

End wheel assembly – Grain Systems Unload Augers PNEG-1050 User Manual

Page 26

background image

26

12" & 14" Commercial Bin Sweep Augers PNEG-1050

Assembly

6. END WHEEL ASSEMBLY

(Refer to Fig. 15.)

(6) Sweep Shield

(2) Sweep Flight

(1) Stub

(3) End Wheel

(4) Collar

(5) Bearing Stand Weldment

1.

Install stub (1) into sweep flight (2) using a 5/8" x 4"
long hex head capscrew and 5/8" nylon lock nut.

2.

Slide bearing stand weldment (5) over stub (1) and bolt
it to the sweep shield (6) using a 3/8" x 3" hex head
capscrew, a 3/8" x 3" long carriage bolt and a

FIG. 15

flatwasher, lockwasher and non-lock nut. Use the
carriage bolt in the slotted hole of the bearing stand (5).

3.

Slide end wheel (3) and collar (4) onto the stub (1). Bolt
the collar (4) in place with a 1/2 "x 3-1/4" long hex head
capscrew and 1/2" nylon lock nut.

See also other documents in the category Grain Systems Equipment: