Grain Systems Unload Augers PNEG-1050 - Manual (Page 24)

24 12" & 14" Commercial Bin Sweep Augers PNEG-1050
Assembly
On units that use four or more sections of flight, a cable
is provided for the sweep back shields. A truss cable
anchor will be attached to the bearing stand and shield
joint of the last section. (See Fig. 13 on page 25) Use
the same 3/8" bolts to connect the sweep back shield,
bracket, and truss cable anchor together.
4. SWEEP CARRIER WHEEL & TRUSS STAND ASSEMBLY
1. Place sweep carrier wheel assembly (1) over
bearing stand (2).
2. Connect carrier wheel (1) and bearing stand (2) to
sweep back shields (3) using a 3/8" x 3-1/2"
carriage bolt with flat washer, lock washer, and
locknut and a 3/8" x 3-1/2" HHCS with locknut.
3. Slide connecting stub (4) through bearing stand
(2) and connect to flighting (5) using four 5/8" x 4"
HHCS with locknuts.
To use a single section of auger flighting with back
shield (or just few sections) for gradual unloading, install
the sweep wheel at the end of the last section used.
Top View
End View
FIG. 12
3/8" x 1"
HHCS with
Locknut
(1) Sweep Carrier
Wheel Assembly
5/8" x 4"
HHCS with
Locknut
3/8" x 3-1/2"
Carriage Bolt
with Flat Washer
and Locknut
3/8" x 3-1/2"
HHCS with
Locknut
5/8" x 4"
HHCS with
Locknuts
(4) Connecting Stub
(2)
Bearing
Stand
(6) Truss
Stand
Sweep Carrier Wheel and Truss Stand Detail
1. Attach truss stand (6) to sweep wheel carrier
assembly (1) using four 3/8" x 3-1/2" HHCS with
locknuts.
A. Carrier Wheel Assembly (For bins with four or
more sections.) (Refer to Fig. 12.)
B. Truss Stand
(3) Sweep
Back Shield
(5) Flighting
Cable
Cable
Cable goes
through this
tube on
truss stand.