Grain Systems PNEG-365 - Manual (Page 29)

29
Grain Systems, Inc. Assumption, Ill.
18' Manual Batch
S-396 3/8" Nuts
S-845 Flatwasher
TD-100039
Sm. Pulley Bracket
Field drill 1/2" dia. hole
TD-100022 Pulley Bracket
TD-100089
Pulley Assembly
S-4750 1/2" x 1.1/2"
Shoulder Bolt (Round Head)
S-845 Flatwasher
S-396 3/8" Nut (2)
S-3949 3/8" x 1" Hex Bolt
Field drill (5) 3/8" diameter holes as shown below. Attach the pulley assembly with 5/16" x 3/4" bolts with the
neoprene on the inside of the bin.
12" from center of hole on the overlap
between top sidewall sheet and second
ring sidewall sheet
TD-100089
Pulley Assembly
S-4749 1/2" x 1.1/4"
Shoulder Bolt
TD-100038 Lg.
Pulley Bracket
Bottom edge of top ring
(horizontal seam)
PULLEY ASSEMBLY
Finish assembling the center collar by adding the cross channel. Position the pulley assembly to the cross channel in
the middle of the center collar assembly. Use a 3/8" x 1" hex head cap bolt to fasten assembly to the cross channel.
Position the pulley in the direction of the desired winch location on the sidewall.
Figure #33
REV. 9-30-96