Grain Systems Tanks PNEG-4060 - Manual (Page 144)

Chapter 8: Accessories
6. Install a ladder reinforcing strap (I) to the ladder standoff brackets (H), and install two hex bolts (J)
and nuts (G).
NOTE: For optimal reinforcement, install the ladder reinforcing straps (I) in a diagonal fashion as
shown.
7. Tighten hardware to the recommended torque specifications. See Bolt Torque Specifications, page
29 .
8. Install the ladder (B) to the starter brackets (C and K), and install hex bolts (M) and nuts (N), but do
not tighten at this time.
9. Install a carriage bolt (Q) to a standoff wedge (O), and insert into the outside channel of the ladder
assembly (B).
10.Connect the standoff wedge (O) to the standoff bracket (H), and install a flange nut (P), but do not
tighten allowing, for adjustment.
144 Pneg-4060 60 Ft Diameter 40-Series Bin