Grain Systems Tanks PNEG-4060 - Manual (Page 142)

Chapter 8: Accessories
Ladder Section Assembly
The inside ladder package consists of the ladder, starter brackets, standoff brackets, reinforcement straps,
and ending bracket. The ladder should to be assembled before installing it to the bin structure.
What You Should Know
When assembling ladder sections, ensure all slip resistant ladder rungs are oriented in the same direction.
NOTE: A portion of the last ladder section may need to be cut to fit the proper length to the ground or to
the intermediate platform.
1. Place two ladder sections (A) together as shown.
2. Install a splice plate (C) to each outside channel, connecting the ladder sections (A).
3. Install flange bolts (D) to each inside channel as shown, connecting the ladder sections (A).
4. Install flange nuts (B) to each outside channel as shown, securing the ladder sections (A). Tighten to
the recommended torque specifications. See Bolt Torque Specifications, page 29 .
Figure 8-15 Assembling the inside ladder sections
A Ladder section C Splice plate (LDR-4317)
B 5/16 in. flange nut (S-3611) D 5/16 x 3/4 in. flange bolt (S-275)
Inside Ladder Placement
The inside ladder provides manway access from inside the bin.
142 Pneg-4060 60 Ft Diameter 40-Series Bin