Grain Systems PNEG-1797 - Manual (Page 19)

2. Decals
PNEG-1797CE CE Approved T-Series Tower Dryer 19
For precise location of all safety decals, please refer to manual provided with the language pack for
the dryer.
DC-2235
High Voltage
Insure that the incoming AC
power and all separate power
sources are turned off and
locked before working on this
equipment
Failure to observe practice
below may result in severe
injury, death, and/or
equipment damage
DC-2236
All maintenance
procedures must be
performed by qualified
personnel who are
familiar with the
operation of this
equipment.
Failure to observe this
warning can result in
serious or even fatal
injury and/or equipment
damage.
DC-2235
DC-2235 is located on inside and outside
main power panel door.
Quantity: 2
DC-2236
DC-2236 is located on inside main power
panel door.
Quantity: 1
DC-2237
Insure that the incoming AC
power and all separate power
sources are turned off and
locked before working on this
equipment
Be sure that charge light and all
LED’s are out before touching any
components.
All test equipment should be
connected and disconnected with
power off.
Ground test equipment, such as
oscilloscopes, may damage the
inverter.
Isolate all instruments from
ground before using. The DC bus
remains charged for several
minutes after power is removed.
DC-2237
DC-2237 is located on inside main power
panel door.
Quantity: 1