Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA User Manual
Page 37
96825 v.6.0
37
table 2: Banks SpeedBrake Fault Codes
If the Six-Gun/EconoMind Diesel Tuner
has been moved to a different vehicle,
or you are instructed to do so by
Banks Technical Staff, it is possible to
reset all of the parameters that the
Six-Gun/EconoMind has ‘learned’ -
presence of an EGT thermocouple or
Speed-Loader, etc.
CAUTION: The following procedures
can only be carried out with the
engine OFF!
1.
Turn the vehicle key to ON but DO
NOT start the engine.
2.
Fully depress the throttle pedal and
then release it completely. Repeat 5
times. The GREEN LED will flash when
this is completed successfully.
3.
Turn the key OFF. Wait 30 seconds,
or until the GREEN LED goes off and
stays off. Turn the key back to the ON
position but DO NOT start the engine.
4.
Fully depress the throttle pedal and
then release it completely. Repeat 5
times.
-END, SECTION 8-
Section 8
CLEARING LEARNED INFORMATION
Section 9
REMOVAL OF THE SIx-GUN/ECONOMIND DIESEL TUNER
If the Six-Gun/EconoMind Diesel Tuner
should ever need to be removed from
the vehicle, perform the following:
NotE: the ignition must remain in the
oFF position throughout the removal
process.
1.
Disconnect the Six-Gun/
EconoMind’s 46-pin connector
(connector c) from the middle
connection on the PcM.
2.
Re-connect the vehicle’s 46-pin
connector back into the middle
connection on the PcM.
3.
Disconnect the Six-Gun/
EconoMind’s MAP connections
from the vehicles MAP sensor and
harness. Re-connect the vehicle’s MAP
connector back into the MAP sensor.
4.
Disconnect the 2-ring terminals
from the EGT thermocouple.
5.
Disconnect the 3 small connectors
on the ‘In-cab cable’ and gently pull
the cable back through the firewall.
6.
Remove the Six-Gun/EconoMind
Diesel Tuner.
Failure to follow the above instructions
when removing the module will result
in a “check Engine” light on the dash
and a Diagnostic Trouble code being
stored in the factory computer, in
addition to the engine not running.
NotE: Banks SpeedBrake & Banks iQ/
PowerPDA will not function without
the Six-Gun tuner installed.
-END, SECTION 9-