Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA - Manual (Page 14)

14
96825 v.6.0
onto the removed mini fuse as shown
in Figure 10. Re-install the mini
fuse with the attached blade tap into
location #22 as shown in Figure 11.
19.
Locate the RED single terminal
connector on the ‘OBDII Interface
cable’ and connect it to the mini-fuse
blade tap location #22. Replace the
fuse cover and make sure not to pinch
the RED single terminal wire.
Mounting The Six-Gun/EconoMind
Diesel Tuner
20.
2003-04 model year vehicles only:
Remove the clip shown in Figure 12
to create adequate room to mount the
Six-Gun/EconoMind Diesel Tuner to the
driver side inner fender.
21.
2003-04 four-wheel drive
vehicles: The module shown in Figure
13 will appear only in four-wheel-
drive vehicles. This may need to be
relocated to make room for the Six-
Gun/EconoMind Diesel Tuner. The
mounting location of this module by
the factory has not been consistent on
early vehicles.
NotE: Make sure all mounting surfaces
are entirely clean and free of dirt
and oil before mounting the Six-Gun/
EconoMind Diesel tuner. Clean and
dry as required using a cloth damped
in rubbing alcohol or similar cleaning
solution.
21.
2005-07 model year vehicles only:
Remove the adhesive backing from
two (2) dual-lock fasteners and attach
them to the Six-Gun/EconoMind shield
and the top of the fuse box.
22.
Remove the adhesive backing
from the (2) dual-lock fasteners on the
back of the Six-Gun/EconoMind Diesel
Tuner and affix the tuner to:
2003-04 model year vehicles: The
inner driver side fender as shown in
Figure 3
NotE: Shield will not be used for
installations on 03-04 models. Shield
will only be used on 05-07 models.
2005-07 model year vehicles: The
inside roof of the Six-Gun/EconoMind
shield, that is mounted on the fuse
box cover as shown in Figure 4 & 6.
-END, SECTION 1-
Figure 9: oBDII interface cable