Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA - Manual (Page 12)

12
96825 v.6.0
12.
Unplug the Manifold Absolute
Pressure (MAP) sensor connector
shown in Figure 7. The MAP
connector can be unplugged by sliding
the red safety slide down, pressing
the locking button, then pulling on the
connector.
13.
Plug the Six-Gun/EconoMind
MAP connector into the MAP sensor.
Plug the factory MAP connector into
the Six-Gun/EconoMind MAP wiring
harness. Route the harness from
the Six-Gun/EconoMind to the MAP
sensor as shown in Figure 8. Use the
supplied zip ties to secure the MAP
harness to the factory harness.
Failure to follow the
recommended harness routing
may result in a melted harness.
14.
Route the Six-Gun/EconoMind
‘In-cab cable’ through the firewall to
the passenger compartment. When
passing through the firewall, either
make a hole in a factory grommet or
drill a hole and use a new grommet.
If drilling, check the backside to make
sure there are no components that
may be damaged by drilling.
15.
Remove the lower driver side
interior panel that allows access to the
fuse box.
16.
From inside the vehicle, continue
to pull the cable through the firewall
until it is approximately 22” inside the
cab. Secure the cable to the lower
access panel area. Take precaution to
leave the three connectors accessible
for usage further in the installation
process.
If Banks SpeedBrake is being
installed, ignore steps 17-19 and
proceed to step 20.
17.
Locate the ‘OBDII Interface
cable’ in your kit. connect the ‘OBDII
Interface cable’ to the vehicle OBDII
connector. Use the large cable tie
in your kit as shown in Figure 9 to
secure the ‘OBDII Interface cable’ to
the vehicle OBDII connector.
Now, connect the 8-pin connector
from the ‘OBDII Interface cable’ to
the 8-pin connector on the Six-Gun/
EconoMind ‘In-cab cable.’
NotE: If you are not installing the
optional Banks iQ then coil up and
secure cable with the RJ12 (telephone
style) connector end.
18.
Remove the fuse box cover,
located in the cabin compartment.
Locate the mini-fuse #22 and remove.
Install the mini-auto blade fuse tap
Figure 6: (2005-07 model year vehicles only) tuner Mounting