Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA - Manual (Page 26)

26
96825 v.6.0
Figure 27
5.
Make sure the suction cup and the
mounting area on the windshield are
clean and dry. With the suction lever
in the up position, ensure the suction
cup is flat against the windshield, and
then push the suction lever down to
secure in place.
6.
Next, remove and set the fuse
access panel aside. See Figure 26.
NotE: For 03-04 models the fuse
access panel is held in place by four
1/4-turn plastic screws.
If applicable, remove the side access
panel to help route wiring to the top of
the dash. See Figure 27.
If installing a Banks SpeedBrake
with a PowerPDA or Banks iQ. Use
step 7 and skip steps 8-10.
If not installing SpeedBrake with an
iQ. Use steps 8-10 and skip step 7.
7.
RJ Connector with SpeedBrake
Banks iQ: Locate Banks iQ Bridge
Module and connect the RJ12 connector
from the Banks SpeedBrake wire
Harness into the Bridge Module. See
Figure 29.
PowerPDA: connect the RJ12
connector from the Banks SpeedBrake
wire Harness into the leftmost
receptacle on the bottom of the Docking
Station.
Skip steps 8-12 if installing a
SpeedBrake with a PowerPDA.
8.
Locate the Banks OBD II Interface
cable in your kit. This cable has
three connection points. connect
the RED OBD II connector on the
Banks interface cable to the vehicle
OBD II connector. Use a cable tie as
shown in Figure 18 to secure the
Banks interface cable to the vehicle