Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA User Manual
Page 35
96825 v.6.0
35
Code
Event
Course of Action
1,1
Injection control
Pressure (IcP) Input
Voltage Out of Range.
Turn ignition OFF and check both 46-pin tuner connections. Turn ignition
back ON and re-check for presence of code.
1,2
Manifold Absolute
Pressure (MAP) Input
Voltage Out of Range.
Turn ignition OFF and check 3-pin MAP sensor connections. Turn ignition
back ON and re-check for presence of code.
1,3
Six-Gun/EconoMind
Switch Input Value
Out of Range.
Turn ignition OFF and make sure either Banks IQ or Six-Gun/EconoMind
switch is connected to Six-Gun/EconoMind tuner. If Six-Gun/EconoMind
switch is connected (no Banks IQ), check 2-pin connection on tuner’s
in-cab cable. Turn ignition back ON and re-check for presence of code.
2,1
Injection control
Pressure (IcP) Output
Voltage Out of Range.
Turn ignition OFF and check both 46-pin tuner connections. Turn ignition
back ON and re-check for presence of code.
2,2
Manifold Absolute
Pressure (MAP)
Output Voltage Out of
Range.
Turn ignition OFF and check 3-pin MAP sensor connections. Turn ignition
back ON and re-check for presence of code.
2,3
Exhaust Gas
Temperature (EGT)
Sensor Open circuit.
Turn ignition OFF and check thermocouple ring-terminal connections (2).
Turn ignition back ON and re-check for presence of code.
3,2
Power Up Error or
Internal Module
Malfunction.
Turn ignition OFF and check fuse-tap power connection to Six-Gun/
EconoMind tuner (under-dash panel). Turn ignition back ON and re-check
for presence of code.
3,3
Internal Module
Malfunction.
Turn ignition OFF and check both 46-pin tuner connections and in-cab
OBD II connection. Turn ignition back ON and re-check for presence of
code.
3,4
cAN communications
Error With Vehicle
ECM, ICM or OBD
System.
Turn ignition OFF and check both 46-pin tuner connections and in-cab
OBD II connection. Turn ignition back ON and re-check for presence of
code.
4,2
Transmission
Slippage Detected.
Transmission is slipping excessively. Code will automatically clear once
transmission stops slipping (repaired).
4,3
Exhaust Back
Pressure (EBP) Input
Voltage Out of Range.
Turn ignition OFF and check both 46-pin tuner connections. Turn ignition
back ON and re-check for presence of code.
4,4
Exhaust Back
Pressure (EBP) Output
Voltage Out of Range.
Turn ignition OFF and check both 46-pin tuner connections. Turn ignition
back ON and re-check for presence of code.
5,1
Internal Module
Malfunction.
Turn ignition OFF and check both 46-pin tuner connections and in-cab
OBD II connection. Turn ignition back ON and re-check for presence of
code.
If problem persists, call Gale Banks Engineering Tech Support.
table 1: Banks Six-Gun/EconoMind Fault Codes