Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA - Manual (Page 30)

30
96825 v.6.0
manifold bolt threads and torque to
28 lb-ft. Use the tightening sequence
shown in Figure 32.
9.
Tighten the turbocharger adapter
pipe fasteners to 20 lb-ft as shown in
Figure 33.
10.
Reconnect the Exhaust Back
Pressure Sensor tap.
11.
connect the thermocouple wires
to the Six-Gun/EconoMind Diesel
Tuner with the supplied screws. The
YELLOW thermocouple wire attaches
to the free YELLOW wire on the Six-
Gun/EconoMind Diesel Tuner. The
RED thermocouple wire attaches to
the free RED wire on the Six-Gun/
EconoMind Diesel Tuner.
12.
Slide the heat shrink over the
exposed metal junction, and supply
moderate heat to seal the connection.
A heat gun works well.
13.
Route the thermocouple to
the exhaust manifold and install the
thermocouple in the fitting.
14.
Reconnect the ground cables to
the vehicles batteries.
Note: once the Six-Gun/econoMind
Diesel tuner is powered up
at key-on, it will ‘learn’ that a
thermocouple is installed. If the
thermocouple is removed after being
installed and run on the vehicle, the
Six-Gun/EconoMind Diesel tuner will
assume that the sensor or connection
has gone bad, and cease adding power
while triggering the [2,3] diagnostic code
(see trouble Shooting Section 7).
-END, SECTION 4-
Figure 31: Location to drill and tap the driver side exhaust manifold for the
thermocouple
Figure 32: Exhaust manifold
tightening sequence
Figure 33: turbocharger adapter
pipe torque specification