Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA - Manual (Page 28)

9.
Looking at the back of the center
dash panel, locate the screw for the
dash plate as shown in Figure 36.
This panel may be blank, or contain
the airbag deactivation switch.
Remove the screw and the plate.
10.
Route the RJ12 cable through
the opening and connect it to the left
most receptacle on the bottom of the
Docking Station. Replace the dash
plate and screw. Re-install center
dash panel.
WARNING: THE CHARGING CABlE
oN THE DoCKING STATIoN
IS DESIGNED To SuPPly A
CoNSTANT loW-VolTAGE PoWER
SouRCE (+5VDC) To THE BANKS
PoWERPDA AND IS “lIVE”
AS loNG AS THE SySTEM’S
oBD II INTERFACE CABlE IS
CoMPlETEly INSTAllED AND THE
RJ12 CoNNECToR IS PluGGED
INTo THE DoCKING STATIoN.
AlTHouGH THIS CHARGING CABlE
IS SHoRT AND ITS CIRCuITRy IS
FuSE-PRoTECTED, THE uSER IS
ExPECTED To TAKE APPRoPRIATE
MEASuRES To PREVENT SMAll
CHIlDREN AND/oR PETS FRoM
CoNTACT WITH ANy PART oF THIS
SySTEM.
11.
Re-install the electric connector
bracket that was removed in Step
4 of Section 5, below the steering
column in the front of the firewall
with the original two (2) bolts. Route
all wiring away from any pedals or
other moving components. Using the
cable ties supplied, secure the wiring
under the dash. Secure all wiring
under the hood away from heat
sources or sharp edges. Re-install the
lower dash panel.
12.
Your Docking Station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the Docking Station.
Be sure the Banks PowerPDA is
completely seated in the Docking
Station against the lower support
bracket.
13.
Plug the Docking Station’s
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA. NOTE: There may
be a snug fit when installing the
Banks PowerPDA into the Docking
Station. Take care not to force this
process.
-EnD, SECTIOn 6-
Figure 36
Figure 37
28
96812 v.7.0