Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA - Manual (Page 23)

11.
Locate the crankshaft Position
(cKP) sensor on the lower front left
side of the engine. It is behind the
engine crankshaft pulley (engine
harmonic balancer). Unplug the
factory connector and plug it into
the corresponding male cKP sensor
connector on the EconoMind
harness. Plug the EconoMind’s
female cKP sensor connector into
the sensor. Take care to route the
wire harness away from the power
steering pump pulley and secure
it with the supplied cable ties. See
Figure 25.
12.
Locate the camshaft Position
(cMP) sensor below the fuel
injection pump between the timing
gear cover and the EcM. Unplug
the factory connector and plug it
into the corresponding male cMP
sensor connector on the EconoMind
harness. Plug the EconoMind’s
female cMP sensor connector into
the sensor. See Figure 26.
13.
Attach the supplied
thermocouple lead wire extension to
the previously installed thermocouple
with the supplied nuts and bolts. The
YELLOW extension wire attaches to
the YELLOW thermocouple wire, and
the RED extension wire attaches to
the RED thermocouple wire.
14.
Route the thermocouple lead
wire extension along the factory
harness to the driver’s side and
connect it to the EconoMind harness.
cover both joints with the supplied
heat shrink tubing and heat until the
tubing conforms to the joint. Make
sure the entire joint is insulated.
Figure 25
Figure 26
96812 v.7.0
23