Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA - Manual (Page 26)

Note: This system has been
designed for use with the Palm
Tungsten E2 PDA.
Warning: The PDA may be
susceptible to damage as a
result of extended exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the PDA be removed from
its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage to
PDAs resulting from exposure
conditions.
Locate the Docking Station in your
kit. The mounting location of the
Docking Station is vehicle specific.
It is not a universal fit. Make sure to
do a dry pre-fit before permanently
mounting. See Figure 31.
Note: In cold climates, best
results will be obtained if the
vehicle’s heater is run to bring the
inside temperature up to “room
temperature” (at least 68°F).
1.
clean mounting area with the
supplied alcohol pad or similar
residue free cleaning agent to
prepare the surface for the adhesive
tape.
2.
The Docking Station has adhesive
tape applied to it at the factory.
Prior to removing the protective liner
from the tape, test fit the unit on
the dash as indicated in Figure 31.
The Docking Station will fit the dash
contours only where shown in the
photo.
3.
After test fitting, remove the liner
from the adhesive tape on the back
of the Docking Station.
4.
carefully align and secure the
Docking Station to the dash in the
same location as it was test fit. Press
the Docking Station firmly against the
dash for one minute to ensure good
adhesion.
5.
Locate the RJ12 cable (similar
to telephone connector) previously
secured behind the knee panel.
Remove the knee panel to gain
access to the RJ12 cable and pull
enough cable through to reach the
Docking Station. (See Figure 32)
Section 6
MouNTING THE DoCKING STATIoN AND CoNNECTING THE BANKS PoWERPDA
VEHIClE CoMMAND CENTER
Figure 31
Figure 32
26
96812 v.7.0