Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA User Manual

Page 19

Place the EconoMind Diesel

Tuner box on top of the fuse box

located in the left front side in the

engine compartment. See Figure

19. The in-cab cable with the three

small connectors will be routed into

the cabin via the grommet on the

firewall. The other two harnesses

will be routed under the intake to

their respective locations listed in the

following steps.

Locate the rubber grommet on the

drivers side firewall. Using a utility

knife, make a 1.5-inch-long slit in the

grommet next to the wire harness.

Be careful not to cut or damage

the harness. See Figure 20 for the

proper location of the required cut.

Insert a screwdriver from the engine

compartment into the cut hole and

gently thrust it through the grommet.

Inside the vehicle, remove the

lower dash panel beneath the

steering column by removing the two

(2) screws at the bottom of the panel.

Retain the screws for re-installation.

NOTE: There are also two (2) clips

located at the top corners of the

panel, which hold the panel in place.

These clips can be released by gently

pulling on the corners of the panel.

Use caution to avoid damaging the

panel during removal.

Section 5

BANKS ECoNoMIND DIESEl TuNER INSTAllATIoN

Figure 18 EconoMind and supplied wiring harnesses

96812 v.7.0