Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 8)

8
96801 v.9.0
2.
The Docking Station has adhesive
tape applied to it at the factory. Prior
to removing the protective liner from
the tape, test fit the unit on the dash
as indicated in the appropriate photo.
Refer to the figure list above for
vehicle-specific mounting locations.
The Docking Station will fit the dash
contours only where shown in the
photos.
3.
After test fitting, remove the liner
from the adhesive tape on the back of
the Docking Station.
4.
carefully align and secure the
Docking Station to the dash in the
same location as it was test fit. Press
the Docking Station firmly against the
dash for one minute to ensure good
adhesion.
Vehicle specific instructions
follow.
For Dodge (‘03-05) proceed to step 5.
For Chevy/GMC (01-08) LB7-LMM
proceed to step 15.
For Dodge (‘06-07) proceed to step 15.
For Ford (’08-09) proceed to step 15.
For Ford (’03-’04) proceed to step 23.
For Ford (’05-07) proceed to step 32.
After completing the mounting
process, proceed to Section 4.
Dodge (‘03-05)
Note: The Docking Station must be
connected to the previously installed
Banks PowerPDA-compatible Six-Gun
tuner via an RJ12 cable. If your Six-Gun
tuner is not installed, refer to the Six-
Gun tuner owner’s manual to install
the tuner before proceeding.
5.
To route the RJ12 cable connecting
the Docking Station to the Six-Gun (see
Six-Gun owners manual for details),
you will need to unclip the knee panel
(See Figure 10) Pry and unclip as
needed to gain enough clearance to
route the cable behind the panel.
6.
Locate the RJ12 cable on your
Six-Gun wiring harness and pull
enough cable through to reach the
bottom of the Docking Station.
7.
Locate and remove the screw in
the dash panel above the hook as
shown in Figure 11.
8.
Remove the dash panel by gently
pulling and unclipping it as needed.
(See Figure 12).
9.
Guide the RJ12 cable through the
clearance between the removed panel
and the dash as shown in Figure 13.
10.
Looking at the back of the dash
panel, locate the screw for the dash
plate as shown in Figure 15. This
panel may be blank, or contain the
airbag deactivation switch. Remove
the screw and the plate.
11.
Route the RJ12 cable through
the opening and connect it to the left
most receptacle on the bottom of the
Docking Station. Replace the dash
plate and screw.
Warning: The charging cable on
the Docking Station is designed
to supply a constant low-voltage
power source (+5VDC) to the
Banks PowerPDA and is “live”
as long as the system’s oBD II
interface cable is completely
installed and the RJ12 connector
is plugged into the Docking
Station. Although this charging
cable is short and its circuitry
is fuse-protected, the user is
expected to take appropriate
measures to prevent small
children and/or pets from contact
with any part of this system.
12.
Refit the dash panel and knee
panel by carefully snapping them back
into place. Tuck any excess cable
behind it for a clean appearance.
See Figure 14.