Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 28)

28
96801 v.9.0
Section 9
SYSTEM MoNIToRS
The default System Monitor screen
displays the following: Gauges G1, G2,
G3, G4, Power level, Status Indicator,
Hist-O-Graph and a Status Window.
See Figure 43. The top two gauge
displays (G1 and G2) are EGT and
BOOST, which cannot be changed.
The bottom two gauges (G3 and
G4) can be changed to display the
available ‘Parameters’. Refer to
section 10 for instructions on
changing the G3 and G4 gauge
displays. The selectable power levels
are 1 thru 6 and SL (Speed Loader).
(Refer to Section 5-changing Power
Levels). Below the Power Level
Indicator is the Status Indicator. When
communications are established
between the Banks PowerPDA ,
Six-Gun Tuner and vehicle PCM then
an ’OK’ will be displayed. In the event
that an on-screen alert or Six-Gun
malfunction is triggered, the indicator
will show an icon relative to the alert.
The lower half of the screen displays
a Hist-O-Graph, which displays a
continuous graph of EGT and boost
readings. ‘Hist-O-Graph’ is the name of
the default System Monitor screen.
1.
To change the ‘System Monitor’
screen press the center button on the
5-way navigator. This will take you to
the System Menu screen.
Figure 43
GAUGE G1
GAUGE G2
GAUGE G3
GAUGE G4
HIST-O-GRAPH
EGT(˚F)
POWER LEVEL
INDICATOR
STATUS INDICATOR
BOOST(PSI)
STATUS WINDOW