Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 12)

12
96801 v.9.0
13.
Your Docking Station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the Docking Station.
Be sure the Banks PowerPDA is
completely seated in the Docking
Station against the lower support
bracket.
14.
Plug the Docking Station’s
charging cable into the charging
receptacle on the lower edge of
the Banks PowerPDA. (Figure 16)
NOTE: There may be a snug fit when
installing the Banks PowerPDA into
the Docking Station. Take care not
to force this process.
-(Dodge 03-05) Skip to Section 4
Universal Mount
-Dodge (06-07)
-Chevy/gMC (01-08)
LB7-LMM
-Ford (08-09)
15.
Locate the Universal Mount and
Docking Station in your kit. Now
interlock the docking station to the
Universal Mount by inserting and sliding
the Universal Mount tabs into the
Docking Station grooves. See Figure 17.
16.
Loosen both knobs and move and
the swivel suction plate and Docking
Station to achieve desired viewing
angle of PowerPDA screen. Do a test
fit and note the angle necessary to
achieve the correct viewing angle.
Tighten both knobs to lock in the
position. See Figure 17.
Note: If the universal mount swivel
does not move or is tight after
loosening the hold down knob, then
remove the previously inserted
docking station and slightly loosen the
tension screw. See Figure 18.
17.
Locate the alcohol swap in the
kit. clean the suction cup and the
mounting area on the windshield and
let dry. With the suction lever in the
up position ensure the suction cup is
flat against the windshield then push
suction level down to secure in place.
Connecting the RJ12 cable to the
docking station.
18.
Locate the RJ12 cable (similar to
telephone connector) on your Six-Gun
wiring harness and pull enough cable
through to reach the Docking Station.
Figure 17