Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 30)

30
96801 v.9.0
Note: There are multiple selectable
parameters to choose from. Specific
parameters vary with vehicle
application
1.
Press the center button on the
5-way navigator to take you the the
System Menu screen.
2.
Next, touch the ‘Gauge Setup’
button. See Figure 48.
3.
The current gauge display will be
shown in G3 and G4 (See Figure 45).
To change the displayed parameter,
scroll through and select from the
available parameters.
4.
Use the buttons labeled ‘Up’ and
‘Down’ to scroll through the list.
5.
To select the desired parameter,
highlight it by touching on the
parameter then touch on either the
G3 or G4 gauge button. The respective
gauge display will change accordingly.
6
Press the ‘Back’ button twice to
return to the System Monitor screen.
The System Monitor screen will
now display your new G3 and G4
parameters.
-END, SEcTION 10-
Section 10
gAUgE SET-UP
Figure 48
The ‘On Screen Alert’ menu allows
you to configure the volume control
for alarms and the corresponding
parameter to be monitored. The
available alerts icons can be seen
in Figure 49.
1.
Press the center button on the
5-way navigator to take you to the
System Menu screen.
2.
Next, touch the ‘On Screen Alerts’
button.
3.
On the ‘Set Volume for Alerts’
screen, touch the desired sound level
to set the alarm level. See Figure 50.
4.
Touch the ‘Next’ button to move to the
‘On Screen Alerts’ screen. Figure 51.
Section 11
oN SCREEN ALERTS
EXHAUST GAS TEMP
ENGINE COOLANT TEMP
ENGINE OIL TEMP
TRANSMISSION TEMP
SIX-GUN TUNER FAULT
Figure 49