Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 43)

96801 v.9.0
43
6.
check the 6-pin or 8-pin connection
to the Six-Gun Tuner’s in-cab cable
(under the driver’s-side dash area/foot-
well). check for any damaged, loose
or broken terminals in both the male
or female connector halves.
7.
check the connection at the OBD II
diagnostic port (under the driver’s side
dash area). check for any damage to
the ODB II connector “hood”, such as if
it has become dislodged from the red
connector housing.
8.
Check the Six-Gun Tuner’s power
connection and fuse (refer to the
Six-Gun Tuner user’s manual for
troubleshooting details).
Loss of tuner-added power
(fueling)
9.
check to make sure the Banks
PowerPDA’s Status Window is
displaying “Connected to Banks Six-
Gun”, indicating the tuner is powered-
up and communicating properly to
the Banks PowerPDA/Docking Station.
If the Status Window is displaying
“SEARCHING…. For Banks Six-Gun”,
the tuner may have become
un-powered. Check the Six-Gun
Tuner’s power connection and fuse
(refer to the Six-Gun Tuner user’s
manual for troubleshooting details).
10.
check the Banks PowerPDA’s
Power Level Indicator for the proper
setting (Power Level “1” is stock
vehicle power).
11.
check the Banks PowerPDA’s
Status Indicator for the “OK” icon. Any
Six-Gun Tuner fault will be indicated
by the “Banks Engine” icon shown
in Figure 81, and its cause can be
investigated by going to the ‘Self
Diagnostics’ screen and scrolling
through the list of
logged tuner events.
12.
check for vehicle OBD II
diagnostic codes by going to the Banks
PowerPDA’s ‘OBDII codes’ screen
and touching ‘check for codes’. If
any diagnostic codes are present,
troubleshoot/repair the cause. Once
the cause is properly remedied, touch
‘clear codes’ and then ‘check for
codes’ again to verify the problem
is fixed (the ODB II code should not
re-appear).
13.
Re-verify the ‘Six-Gun Tuning’
parameters to make sure the loss
of added fueling is not caused by
improper settings of these parameters.
Pressing ‘Restore All’ will set the Six-
Gun Tuner back to factory defaults.
14.
Refer to the Six-Gun Tuner user’s
manual for further troubleshooting
details.
-END, SEcTION 21-
SIX-GUN TUNER ICON
Figure 81