Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 42)

42
96801 v.9.0
Figure 78 Figure 79 Figure 80
Figure 75 Figure 76 Figure 77
1.
Unplug the charging cable from the
bottom of the Banks PowerPDA.
2.
Take hold of the Banks PowerPDA
by gently applying pressure to the top
front edge and pulling towards you.
3.
Reposition your hold on the Banks
PowerPDA by grasping the top outer
edges and gently, in one swift motion,
pull upwards and out of the Docking
Station. See Figure 75 thru 80.
-END, SEcTION 20-
Section 20
REMoVAL oF ThE BANKS PoWERPDA FRoM ThE DoCKINg STATIoN
Section 21
TRoUBLEShooTINg
Loss of communication (Banks
PowerPDA Status Window
displays “SEARChINg…. For
Banks Six-gun”)
1.
Make sure the vehicle ignition key
is ON.
2.
Make sure the Banks PowerPDA is
fully-seated in the Docking Station.
3.
Make sure the infrared emitter/
detector lenses on the Docking Station
are not obstructed (by excessive
dust, dirt, etc…) or damaged. These
lenses are visible from the front of the
Docking Station, immediately above
the top edge of Banks PowerPDA).
4.
check the OBD II Interface cable.
5.
check the RJ12 connection at the
Docking Station. Remove the RJ12
connector from the Docking Station
and inspect the 6 contacts inside
the Docking Station’s left-most RJ12
receptacle. If these contacts are
damaged or bent, either of the other
two RJ12 receptacles can be used
instead AS LoNg AS NoNE oF ThE
CoNTACTS INSIDE ANY oF ThE
RJ12 RECEPTACLES ARE ShoRTED
TogEThER. Do NoT INSERT ANY
METALLIC oBJECT (SCREWDRIVER,
ETC…) INTo ANY oF ThE UN-USED
RJ12 RECEPTACLES WhILE ThE RJ12
CABLE IS INSTALLED – DAMAgE
To ThE DoCKINg STATIoN CAN
RESULT.