beautypg.com

Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) User Manual

Page 13

background image

96801 v.9.0

13

Figure 19 Dodge (06-07) Shown

19.

Route the RJ12 cable to reach the

Docking Station and connect it to the

left most receptacle on the bottom of

the Docking Station. See Figure 19.
Note: You may need to remove and or

loosen dash panel or covers to install

the RJ12 cable between dash crevice

or behind dash panels. See Figure 19
WARNINg: ThE ChARgINg CABLE

oN ThE DoCKINg STATIoN IS

DESIgNED To SUPPLY A CoNSTANT

LoW-VoLTAgE PoWER SoURCE

(+5VDC) To ThE BANKS PoWERPDA

AND IS “LIVE” AS LoNg AS ThE

SYSTEM’S oBD II INTERFACE CABLE

IS CoMPLETELY INSTALLED AND

ThE RJ12 CoNNECToR IS PLUggED

INTo ThE DoCKINg STATIoN.

ALThoUgh ThIS ChARgINg CABLE

IS ShoRT AND ITS CIRCUITRY IS

FUSE-PRoTECTED, ThE USER IS

EXPECTED To TAKE APPRoPRIATE

MEASURES To PREVENT SMALL

ChILDREN AND/oR PETS FRoM

CoNTACT WITh ANY PART oF ThIS

SYSTEM.

20.

Route all wiring away from any

pedals or other moving components.

Using the cable ties supplied, secure

the wiring under the dash. Secure all

wiring under the hood away from heat

sources or sharp edges.

21.

Your Docking Station is now

installed and is ready for the Banks

PowerPDA. Install the Banks PowerPDA

into the Docking Station. Be sure the

Banks PowerPDA is completely seated

in the Docking Station against the

lower support bracket.

22.

Plug the Docking Station’s

charging cable into the charging

receptacle on the lower edge of the

Banks PowerPDA.
NOTE: There may be a snug fit when

installing the Banks PowerPDA into

Figure 18

See also other documents in the category Banks Power For the car: