Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 32)

32
96801 v.9.0
checking for OBD II Diagnostic codes
1.
Press the center button on the
5-way navigator to take you the
the System Menu screen.
2.
Next, touch the ‘OBD II’ button.
3.
With the ignition in the on/run
position or with the engine running,
touch the button labeled ‘check For
codes’. See Figure 53.
Note: The Banks PowerPDA will
check for vehicle diagnostic codes
and display either the p-code with a
brief description of the code or the
message “Done! – No Codes Present”.
For a full description of the code,
highlight the code and a window will
pop up with a detailed explanation.
4.
To return to the System Menu
touch ‘
were found and you would like to
clear them, proceed to step 5.
clearing OBD II Diagnostic codes
5.
After checking for and reviewing
any diagnostic codes, touch ‘clear
codes’ to erase them from the vehicle
EcU. If multiple codes are present,
they will all be cleared.
NOTE: On Dodge vehicles, the ignition
key must be in the On/Run position,
but the engine must NOT be
running. If the engine is running,
Banks PowerPDA will display a pop-up
message instructing you to check the
ignition key is in the ON position.
6.
Press’Check For Codes’ again to
verify the OBD II codes were erased.
Some status monitor codes require a
certain amount of engine “run time”
in order to be cleared (i.e. P1000 on
Ford).
7.
If diagnostic codes reoccur on your
vehicle, you should investigate the
underlying problem to correct it.
-END, SEcTION 12-
Section 12
ChECKINg AND CLEARINg oBD II DIAgNoSTIC CoDES
Figure 53