Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 16)

16
96801 v.9.0
the Six-Gun tuner owner’s manual to
install the tuner before proceeding.
32.
Remove the fuse access panel
below the steering column by pulling
on it with the handles as shown in
Figure 24.
33.
Remove the smaller dash panel
immediately to the right as shown in
Figure 25. Unclip it by pulling in the
area shown in the picture.
34.
Locate the RJ12 cable from
your Six-Gun Wiring harness and
route it to the bottom of the Docking
Station behind the panels you’ve just
removed.
35.
connect the RJ12cable to the left-
most receptacle on the bottom of the
Docking Station.
Warning: The charging cable on
the Docking Station is designed
to supply a constant low-voltage
power source (+5VDC) to the
Banks PowerPDA and is “live”
as long as the system’s oBD II
interface cable is completely
installed and the RJ12 connector
is plugged into the Docking
Station.
Although this charging cable is
short and its circuitry is fuse-
protected, the user is expected
to take appropriate measures
to prevent small children and/or
pets from contact with any part
of this system.
36.
Refit the dash panel by carefully
snapping it back into place. Refit the
fuse access panel and tuck any excess
cable behind the panels for a clean
appearance. See Figure 24.
37.
Your Docking Station is now
installed and is ready for the Banks
PowerPDA. See Figure 23. Install the
Banks PowerPDA into the Docking
Station.
Be sure the Banks PowerPDA is
completely seated in the Docking
Station against the lower support
bracket.
38.
Plug the Docking Station’s
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA.
NOTE: There may be a snug fit when
installing the Banks PowerPDA into
the Docking Station. Take care not
to force this process.
-END, SEcTION 3-
Figure 23 Ford (’05-07)