Rough Country 376.20 - Manual (Page 3)

12. Using the 18mm socket reinstall the hub assembly and dust cover on Rough Country spindle using the 3 factory
bolts. Torque to factory specs. See Photo 7.
13. Using a 16mm socket remove sway bar links, the links and hardware will not be re-used. See Photo 8.
14. Remove factory shocks using a 13mm socket for the bottom and a 18mm wrench for the top. See Photo 9.
15. Remove the factory coil springs.
16. Using a 21mm wrench and a 24mm socket remove the lower control arms. Retain factory hardware for re-use. See
Photo 10.
17. Hang the new Rough Country front cross member in place. Use factory hardware from lower control arms to bolt in
place, do not tighten at this time.
18. Hang the new Rough Country rear cross member in place. Use factory hardware from lower control arms to bolt in
place, do not tighten at this time. See Photo 11.
19. Reinstall lower control arms using the 5/8”x5.5” bolts, washers, and nuts provided in 1376Bag1. Do not tighten at
this time. See Photo 12.
Photo 7 Photo 8
Photo 9 Photo 10
Photo 11 Photo 12