Rough Country PERF619 - Manual (Page 11)

PHOTO 37
Drill using a 13/32” drill bit
PHOTO 38
Install 3/8” X 2” Bolt, washers & nuts
56.Remove the stock front brake line from the metal line at the frame rail using a 3/8” wrench. Remove the brake line
from the caliper using a 14mm socket. Retain stock hardware to reinstall the brake line. A catch pan is recom-
mended to avoid a fluid mess. See Photo 33.
57.Remove the stock line from the frame rail using a T30 Torx head bit. Retain the bolt for reuse.
58.Install the new brake line bracket on the frame rail as shown in See Photo 34 with the stock hardware using a
T30 Torx head bit. Install the new Rough Country brake line on the stock metal line and install supplied brake line
clip. Install on the caliper with stock caliper bolt and brake line washers using a 14mm socket. Install the caliper on
the axle and tighten using a 13mm socket.
59.Grind the back side of the mount smooth to allow the track rod bracket to be installed. See Photo 35.
60. Install the new track rod bracket on the frame as shown in Photo 36 using the supplied 1/2” x 1 3/4” bolt, washer
& nut in the stock mount. Tighten using a 19mm Socket & wrench. View from the passenger side.
61. Using the bracket as a guide, drill the upper hole using a 13/32” drill bit. See Photo 37.
62. Install the supplied 3/8” x 2” bolt in the drilled hole with the washers & nut. Tighten using a 9/16” socket & wrench.
See Photo 38.
PHOTO 35
Grind Bracket Flat
PHOTO 34 PHOTO 33
Remove the stock rubber line Install the brake line bracket on the frame
PHOTO 36
Install 1/2” X 1 3/4” Bolt , washer & nut