Rough Country 54720-15 - Manual (Page 9)

Rev. G 0412 54720 pg. 9
Supertop NX Installation Instructions
Remove the Rear Window from the box and lay it
fl at with the backing side up. Locate the Tailgate
Bar set aside in Step One. The bar has a “C”
shaped channel, when viewed from the end. Orient
the bar with the round seal down and slide the “C”
channel on the retainer onto the tubed strip sewn to
the backing side of the Rear Window.
Rear Window -
Backing Side
Tailgate Bar Tailgate Retainer
Channel
Tubed
Strip
Install Tailgate Bar on
Rear Window
Insert the Tailgate Bar into the mounts on each side
of the tailgate opening with the vinyl side of the Rear
Window toward the outside of the vehicle.
Place Tailgate
Bar in mounts
Install Tailgate Bar on Vehicle
To start the zipper, pull the two sliders as far
down as possible on the driver’s side of the
window in order to catch the sliders to the pin.
Once the zipper is caught, start the top slider
1/2". Then hold up the top of the window with
one hand and close the zipper with the other.
The zipper is sandwiched between layers of
fabric in the corners so be careful not to catch
extra fabric in the zipper. Close the zipper.
Make sure that the Tailgate Bar is centered and
is securely in the mounts. Then tuck the fl aps
on the Rear Window under the tailgate mounts.
Tuck Flaps
under top
Pull both sliders
down as far as
possible to catch pin
Start
Zipper
Secure Rear Window Zippers
Inside the top locate the fl aps sewn to the top on
each side of the rear window opening. Pull the fl aps
over to cover the zipper and tuck them in.
View from inside top
Rear Window
Pull fl ap
over to cover
zipper and
tuck in
Rear Window Flaps