Rough Country PERF663 - Manual (Page 12)

63.Install the upper arm on the axle using the stock hardware. Do not tighten at this time. See Photo 40.
64.Locate the new track rod bracket and install on the rear axle mount as shown in Photo 41 with the supplied crush
sleeve using the stock bolt and flag nut. Tighten using a T55 torque head bit.
65.Install the supplied 5/16” x 1” bolts, washers & nuts in the bracket as shown in Photo 42. Tighten using a 13mm
wrench.
66. Install the track rod on the frame mount on the passenger side using the factory hardware. Do not tighten at this
time. The track rod will be installed on the axle and tightened on both ends after the vehicle has been lowered to
the ground and is supporting it own weight. This is done to ensure the axle is centered under the body.
67. Separate the stock rubber line from the steel line at the axle using a 3/8” brake line wrench and remove the stock
brake line from the axle using a 9/16” wrench. See Photo 43 & 44.
68. Separate the steel line from the rubber line on the frame as shown on Photo 45 and remove the rubber line from
the frame using a T30 torque head bit. Retain the factory hardware.
PHOTO 40
Install the upper arm using stock hardware
PHOTO 41
PHOTO 42
Install supplied sleeve and stock bolt
Install supplied 5/16” x 1” hardware
PHOTO 43
Remove steel line from line on axle
PHOTO 44
Remove the stock brake line from axle
PHOTO 45
Remove the stock from the frame steel line