Rough Country 51124-15 - Manual (Page 9)

51124 pg 9
Rev. B 0204
Installing the New Door Covers Note: For the best results and to
minimize scratches on the windows,
remove all jewelry before installing
the door covers.
1. Install Lower
Rear Corner
3. Install Upper
Front Corner
Unzip Window
before installing
Hook and
Loop
Note: This door cover is designed to fit very
tight on the door frame. We recommend
using a shoe horn to help work the corners
of the cover over the frame without tearing
the fabric.
WARNING
Do not pull on the weatherstrip to assist in
getting the door cover on the door frame.
This will tear the weatherstrip and the door
will not seal properly.
4. Use tab to install
Upper Rear Corner
2. Install Lower
Front Corner
Weatherstrip
Detail of Hook and Loop -
Lower Front Corner
Pull Flap Up
First
Hook and
Loop
Detail of Hook and Loop -
Top of Door
Door Frame Between
Hook and Loop Flaps
Step Sixteen
Remove the fabric upper doors from the vehicle. Use
a razor knife to cut the stitches on the old door covers
and take them off of the door frames.
Step Seventeen
Unzip the windows and separate the hook and loop fasteners
on the door covers. Lay the door cover on a flat smooth surface
with the outside facing down.
Start by working the lower rear corner of the door frame into the
pocket in the lower rear corner of the cover. Then work the
lower front corner of the frame into the cover. Work the top front
corner of the frame into the corner of the cover, between the
hook and loop flaps (not between the zipper and the flap).
Finally, use the tab sewn into the cover to work the last corner of
the frame into the corner of the door cover, again between the
hook and loop flaps.
Make sure that the top edge of the door cover is straight along
the top of the door frame. Work around the door fastening the
hook and loop strips tightly around the door frame. Once the
door cover is on the frame, the tab in the top rear corner of the
cover may be cut off with a pair of scissors if desired.
Step Eighteen
Reinstall the upper doors. Insert the pins
into the grommets in the lower door.