Rough Country 51124-15 - Manual (Page 7)

51124 pg 7
Rev. B 0204
Step Eleven
Close the zippers on the Quarter Panels the rest
of the way to the lower rear corner of the panel.
Start at the rear and roll the plastic along the
bottom of the panel into the retainer on the
vehicle. Then fasten the hook and loop strips
along the top and rear of the panel to the top.
Roll Plastic Strip into
channel in retainer
Close Zipper
Fasten Hook and
Loop Strips
Step Twelve
Remove the Rear Window from the box and lay it flat with the
backing side up. Locate the Tailgate Bar set aside in Step One.
The bar has a "C" shaped channel, when viewed from the end.
Orient the bar with the round seal down and slide the "C"
channel on the retainer onto the tubed strip sewn to the
backing side of the Rear Window.
Tailgate Retainer
Tailgate Retainer
channel
Tubed Strip
Rear Window -
Backing Side
Roll Plastic Strips into channel
above door opening
Step Ten
Locate the two plastic strips sewn to the sides of the top,
above each door. Slip the strips into the channel in the
Door Surround above the door opening. It is easiest to
insert the front plastic strip into the channel first.