Rough Country 785.22 User Manual
Page 18
3. Slide the new exhaust loop over the factory cut exhaust and hand tighten. See Photo 3.
4. Using the supplied 7/16” x 2.5’ bolts and flange nuts attach the exhaust loop to the factory flange. Make sure the ex-
haust pipes are in align with each other. Tighten with a 11/16 and 5/8 wrench. See Photo 4. Next tighten the upper
clamp using a 15mm wrench.
5. If your jeep is already equipped with aftermarket exhaust extensions use the supplied 7/16” x 3.5” long bolts instead
of the shorter 2.5” bolts. This will allow you to insert the extension between the exhaust flanges. See Photo 5.
POST INSTALLATION INSTRUCTIONS
•
All hardware must be tightened at 500 miles after installed and then checked periodically to ensure all fasteners are
tight.
PHOTO 3
PHOTO 4
PHOTO 5
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)