Rough Country 56820-15 - Manual (Page 4)

Rev. H 0113 56820 pg. 4
Trektop NX Installation Instructions
Lay the top fabric, backing side up and aligned with
the front edge of the Header. Use a utility knife to
slit the fabric over each screw position. Locate the
round hole that marks the center of the plastic strip
(all other holes are slotted). Install a #8 x 5/8" Pan
Head Screw in the round hole to secure the fabric to
the header as well as to center the top. Then install
#8 x 5/8" Pan Head Screws in the remaining seven
holes along the front of the header.
Install an Oval Head Screw in the outside holes on
each side of the Header.
Install Top Fabric on Header
Install #8 x 5/8"
Pan Head Screws
Start in
Center
Oval Head
Screw
Fold the Top Fabric toward the front of the Header.
Place the Header on the vehicle. Pull the release
knob on the Side Bow and insert the pin into the
Door Surround Bracket. Repeat on the other side of
the vehicle.
Mount Header Assembly to
Door Surround
Pull the Top Fabric back over the Top Arch and
sport bar.
Drape Top Fabric Over Vehicle
Slide the Rear Bow into the pocket inside the rear of
the Top Fabric. Secure the J-Hooks on the rear bow
fl aps to the ends of the Rear Bow.
Install Rear Bow
Rear Bow Hook J-Hook
to Rear Bow