GLOBALSAT TR-203A - Manual (Page 81)

80
10 Timer
There are four timers for setting specified time report.
For Timer 0, when there is a new event (report), it will re-start to count down
the report interval again.
Timer 1 ~ 3 will not count down the report interval when there is a new event.
10.1 Timer 0
The following parameters must be set for configuration or
sending those parameters by other action command:
Code
word
Parameters Value Description
W0 Start time 0~86400
W1 End time 0~86400
W2 Report interval 1~65535
W3 Weekday mask 00~7f u8, xx(hex digits)
W4 Report Media
Please refer to
2.9 Report media
10.2 Timer 1~3
The following parameters must be set for configuration or
sending those parameters by other action command:
(“X”:Timer 1, “Y”:Timer 2, “Z”:Timer 3,)