GLOBALSAT TR-203A - Manual (Page 12)

11
2.7 Configuration Parameters
Most behaviors of TR-203 could be changed by Configuration Parameters. You
could change the setting of configuration parameters by the following methods.
1. Connect TR-203 to personal computer via USB cable and then set the
configuration parameters by “TR203 Config Tool.”
2. Send the “GSS,….!” setting with the configuration parameters to TR-203
3. Send the “GSC,….!” command with the configuration parameters to TR-203
All the settings or commands could be sent by SMS or TCP or UDP.
You could also send L1 command to read the present setting of TR-203.
Configure Parameters
Code
words
Parameters Type Description
O5 Device ID char(16)
O7 Firmware Version char(28) Read only
O6 Time Zone Offset
s32, in
seconds
-43200 ~ 46800
Device
O4
Power on operating
mode
u8
1=Sleeping
2=Periodic
3=On-line
4=Motion
6=Parking
7=Standby
B0 PIN code char(4)
B1
Phone number of SIM
card
char(20)
SIM
B2 IMEI number char(16) Read only
Vibrator
I2
Enable/ disable TR-203
to vibrate after
pressing SOS key
1/0
0=disable
1=enable
Main