Velleman HAA2890 - Manual (Page 21)

ENTRY MODES VALIDATION LOCATION
1
or
2 70 #
USER PIN ENTRY MODE – Auto or Manual (Location 70)
USER PIN ENTRY MODES
Two modes 1 and 2 are available for User PIN entry options. The EM Card is always in Auto Entry Mode and is not
affected by the selection here.
1
--- Auto Entry Mode
Auto Entry Mode requires no pressing of the
#
key following the User PIN for code checking.
In the Auto Entry Mode, the User PINs MUST be set in the same digit length of the Master Code (For example, if
the Master Code is 5 digits, then all User PINs must be in 5 digits as well. All other User PINs not in 5 digits become
invalid). When the number of digits reaches, the system will check the User PIN automatically. Good for high traffic
access control.
2
--- Manual Entry Mode – (Default)
Manual Entry Mode always requires the
#
key following of the User PIN for code checking. The User PINs can be 4-8
digits arbitrary and they are NOT required to be in the same digit length of the Master Code. Manual Entry increases
the level of security in the code trial by the unauthorized people.
PACIFIER TONES ON-OFF SELECTION (Location 71)
PACIFIER TONES ON-OFF MODES
The Pacifier Tone is the Beep Tones from the keypad, which include the tones of Successful Key entry (1 beep), the
Output Operation Announcer (2 beeps or 1 long beep) and the Unsuccessful User Code/Card entry (5 beeps).
NOTE :
The beeps for the Warning and the Power-up Delay do not belong to pacifier tones and can not be set to OFF.
1
--- Pacifier Tone ON – (Default)
All the Pacifier Tones available from the keypad are enabled. They are the response tones indicating the operation
status of the keypad after the Card/User Code is entered.
0
--- Pacifier Tone OFF
All the Pacifier Tones are OFF. Good for place needs for a silent environment.
FUNCTION MODES VALIDATION LOCATION
1
or
0 # 71
21
HAA2890_Manual.indd 25 24/05/2012 15:21:14